Liv Garage Door Repairs & Service Blog

Loud Bang From the Garage: What a Broken Torsion Spring Sounds Like and What to Do Next

November 15, 2026 5 min read
overhead torsion spring above an open garage

It usually happens when the house is quiet. There is a sharp, flat bang from the garage, sometimes loud enough to make you jump in another room, and then silence. The door may be halfway up or all the way down, and the opener may run without moving it. In many cases that bang is a torsion spring breaking, and it is one of the few garage door failures that is mechanically certain: a torsion spring that has snapped cannot hold the weight of the door. This article covers what that failure sounds and looks like, what you can safely observe from outside the door, and what to do before anyone touches the opener again.

What a broken torsion spring sounds like

Homeowners describe it in a few consistent ways: a single hard crack, like a gunshot muffled by the walls; a heavy metallic snap followed by a rattle as the coils unwind; or a bang paired with the door dropping a few inches and stopping. Torsion springs are wound under high tension and store the energy that counterbalances the door. When the wire breaks, that stored energy releases all at once, and the sound is the spring unwinding against its shaft and the door's weight suddenly going uncounterbalanced.

It is worth separating that sound from other garage noises. A rattle that repeats through the whole cycle is usually hardware, such as rollers, hinges, or a loose panel. A squeal that rises and falls with door speed is usually friction somewhere in the track or hinge line. The single bang that ends in silence, with the door stuck where it is, is the pattern that points to a spring.

What you can safely observe

With the garage empty and the door left exactly where it stopped, a few things are visible from outside without touching anything. The door may sit crooked in the opening, with one side higher than the other. There may be a gap along the top of the door where it no longer meets the header evenly. The door may feel heavier than usual when you use it normally, though you should not lift it by hand to check. If the opener was running when the spring let go, the motor may now run without the door moving at all.

What you should not do is go looking for the break. Torsion springs, cables, and the opener drive train are technician work. A spring under tension can injure someone who does not know how it is wound, and a door held up by a broken spring can come down without warning. Leave the door where it is and keep the garage empty until it has been looked at.

Why the door will not work after the bang

A torsion spring carries the weight of the door so the opener only has to guide it. When the spring breaks, that counterbalance is gone, and the full weight of the door comes down on the opener and the cables. The opener is not built to lift that load. Running it repeatedly can strip the gear in the opener, damage the carriage, or pull the door further out of its tracks. If the door is stuck open, the same problem applies in reverse: nothing is holding it, and it can drop.

This is why the advice after a bang is to stop using the opener. Do not press the button to see whether it will work. Do not try to help the door up or down by hand. The door is in an unsafe state until the spring has been replaced and the door has been checked.

What to do next

  1. Keep people and vehicles clear of the door. If a car is inside and the door is stuck open, leave it there rather than moving the door. If the door is closed, do not open it.
  2. Unplug the opener if you can reach the plug safely. This prevents anyone from pressing the remote or wall button out of habit. If the outlet is not reachable without going near the door's hardware, leave it alone.
  3. Call for service. The door should not be used until the spring has been replaced and the door has been checked. Liv Garage Door Repairs & Service takes calls at (425) 386-7589, with 24/7 emergency dispatch and weekday hours of 7:00 AM to 8:00 PM, Monday through Saturday. Sunday is emergency service only.
  4. Note what you heard and saw. Whether the bang came at the start of a cycle or midway, whether the door moved at all, and whether the opener still runs are all useful details when you call.

After the spring is replaced

A spring replacement is not just a matter of swapping the broken part. The technician will check the cables, the drums, the rollers, and the track, because a door that has dropped on a broken spring can bend a track or kink a cable. The opener should also be checked, since it may have taken load it was not designed for. A tune-up and safety inspection afterward is a reasonable way to confirm the door is running correctly before normal use resumes.

If you heard the bang and are not sure what broke, the safest step is the same either way: leave the door alone and have it looked at. Liv Garage Door Repairs & Service serves Auburn, Kent, Federal Way, Renton, Tacoma, Puyallup, Seattle, Enumclaw, Maple Valley, Covington, Bonney Lake, and Sumner. Reach the team at (425) 386-7589 or info@livgaragedoors.com, or at 5548 34th St SE, Auburn, WA 98092. Liv Garage Door Repairs & Service is a registered Washington State contractor.

Need this looked at by a technician? Call Liv Garage Door Repairs & Service.

Call (425) 386-7589